Automatic Electronic Equipment Protector

Features:

• The Dolphin is designed to protect electronic equipment against 
• the hazards of over-voltage and overcurrent caused by under-voltage.

• The fully automatic operation of the protector now enables 
• its use at places where ordinary circuit breakers could not be used, 
• because of tripping problems. Dolphin Automatic Equipment 
• Protector Protect your electronic equipment from High Voltage
• The Dolphin Electronic equipment protector comes in 
• an ergonomic direct-mounting palm-size case. Dolphin supplies 
• power to the equipment as long as the line voltages 
• remain between 165 V and 265V.In case the line voltage 

• falls below 165V and stays there for longer than 0.3 seconds continuously, 
• the supply to the equipment will be cut-off. The Dolphin will 
• automatically resume supply to the load once the line volts are normal. 
• No manual intervention is needed. Similarly, if the line voltage
• rises above 265V and stays there for longer than 0.3 seconds continuously, 

• the supply to the equipment will be cut-off. Again, 
• automatic resumption of supply to the load 
• will take place after the line voltage is normal.
• However, it will wait for approximately 10 seconds to protect the equipment. 
• If power is resumed after more than 10 seconds. 
• The protector will wait for 1.5 seconds only to prevent 
• power back surges from reaching the equipment.